MeatballFlag

joined 1 year ago
[–] MeatballFlag@lemmy.sdf.org 3 points 11 months ago (1 children)

As per usual, the fine becomes simply the cost of doing business

[–] MeatballFlag@lemmy.sdf.org 2 points 11 months ago

I was having the same audio delay issues with speech, take-off/landing sounds, etc when I was playing the game installed on an HDD storage array. I moved the install to the SSD system drive and that's all gone away. Crashes have gone down too, I was crashing 2-3 times in an evening of playing but for the past several days or more I might see one crash in a 4+ hour session. Still more crashing than it should but it's not absolutely terrible

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

Cars don't cease to function when driven in areas with little to no cell reception...

[–] MeatballFlag@lemmy.sdf.org 4 points 1 year ago (3 children)

Because some areas have poor to no cell reception

[–] MeatballFlag@lemmy.sdf.org 17 points 1 year ago (1 children)

I'm sure this will about as effective as D. A. R. E. in American schools and keeping people off drugs

[–] MeatballFlag@lemmy.sdf.org 3 points 1 year ago (1 children)

Maybe because I didn't know what I was doing back then but that was the only way I used Limewire

[–] MeatballFlag@lemmy.sdf.org 0 points 1 year ago

I haven't watched since Orlando went out. Are they still shamelessly rigging games to get Miami to the final?

[–] MeatballFlag@lemmy.sdf.org 3 points 1 year ago (2 children)

Fucking studfinders man...

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

What he said but the season is also on a pause while the Leagues Cup is taking place between MLS and Liga MX

[–] MeatballFlag@lemmy.sdf.org 1 points 1 year ago

I hate the ea launcher with such a burning passion as to outshine the sun. ~80% it causes a problem launching a game for me and provides zero benefits for it's use. It has no consumer friendly reason to exist

[–] MeatballFlag@lemmy.sdf.org 2 points 1 year ago (1 children)

Thanks I'll give some of these suggestions a try. I am printing with PLA at the same temps I've used in the past with the same material. I wouldn't think the change to pei would require a changing of print temp but I'll keep that in mind as well.

 

This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

Thanks for any advice

view more: next ›