this post was submitted on 27 Nov 2023
1 points (100.0% liked)

Home Networking

198 readers
1 users here now

A community to help people learn, install, set up or troubleshoot their home network equipment and solutions.

Rules

founded 1 year ago
MODERATORS
 

TLDNR- Wifi setup to get signal to 25x30 garage 60 feet from house, service comes in first floor 50 feet further from back of house.

Woe is me. Sorry for yet another question.

We have 1000MBps AT&T fiber. Using the Wi-Fi built into the gateway, we barely get a signal to our detached garage.

I failed to add ethernet when I trenched to run electric. Prefer not to because of grounding issues and now there is a sidewalk crossing the backyard.

Currently the fiber connection comes in towards the front of the house. It's about 50 ft from there to the back of the house. Yard is another 60 ft. Then garage is about 30 ft deep.

Just purchase a set of ASUS XT9 Zenwifi. In testing inside the house I'm only getting around 150 to 160 Mbps on the AT&t gateway Wi-Fi. XT9 is only 100Mbps

If I place the node in the back window of the house, I can get 30Mbps at the closest part of the garage, 10Mbps at the farthest.

Do I need a 3 router system? I could probably run ethernet backhaul to the back of the house, but I don't know that it will solve the issue.

I tried to talk one of the ATT fiber techs into running me an aerial fiber cable between the two buildings but no dice.

I know a lot of things are on sale right now so hoping I can get advice and get something still on discount.

you are viewing a single comment's thread
view the rest of the comments
[–] AffectionateJump7896@alien.top 0 points 11 months ago (1 children)

I know power line is bad in many ways. It is also the most simple, so depending on the use the OP has in mind it might be cheap, easy and suitable.

[–] interestingname1@alien.top 1 points 11 months ago

Completely forgot about this, I have a set of TPLink AV2000. Garage is on a subpanel fed by the house but I just tested and they work out there.

Speedtest is only pulling 50/50 Mbps , but its as good or better than the XT9 signal out there.

For now this may be good enough. Testing in the house and I'm getting 350/300 connected to the XT9 after changing the cable. About the same(315/270) connected to the BGW320. Testing using speedtest site on Pixel7 and Framework PC(Intel® Wi-Fi 6E AX210)

Spouse voted for PTP over more AP's in the main house.