this post was submitted on 09 Mar 2024
19 points (95.2% liked)
homeassistant
12055 readers
39 users here now
Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I ran into the same with the "D1 Mini". The few cases available were expensive for what they were and not a great fit for my needs.
If you have access to a 3D printer, there are some pretty good models on thingiverse and printables. But YMMV depending on which board you're using.
Another possiblity... I wanted to permanently put one in my car, so having some basic protection with the least amount of bulk was important. I ended up buying some shrink tube large enough to go around the entire board (IIRC it was 40mm, 2:1 shrink ratio), got everything wired up, slid the tubing over and shrunk it down. Could probably "double wrap" for more complete coverage. Again, this is board dependent and worked well for the D1 since it doesn't have pre-soldered pins.
Cheers!
That's a great idea ๐ I'll get back to that if I can't get a box