homeassistant

12129 readers

11 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

GreatAlbatross

HA redundancy options (self.homeassistant)

submitted 11 months ago by Cyber to c/homeassistant@lemmy.world

17 comments fedilink hide all child comments

I'm currently running HA on a Pi3... it works fine, but it's now a single point of failure.

I have some new hardware arriving to run VMs in and was intending to move HA to it, but now I'm wondering if I can have HA in 2 places for fault tolerance.

I'm aware that there's no built-in failover options, but has anyone done something similar?

you are viewing a single comment's thread
view the rest of the comments

[–] scrubbles@poptalk.scrubbles.tech 2 points 10 months ago (1 children)

You'll need to learn a lot more about kubernetes to decide fully if you want to do it. I'm more or less telling you that yes there are ways to keep it highly available, but they're going to be literally 10x if not more the amount of effort to spin up and probably maintain.

Proxmox has their own flavor of HA that is a lower level of virtualization. They'll be able to failover a specific VM/CT to another node if one fails, but again pros and cons. The major annoyance for both is where do you put your data so 2 separate nodes can access it? Both k8s and proxmox have different approaches.

[–] c10l@lemmy.world 1 points 10 months ago (1 children)

K8s and Proxmox operate at different levels. You can run k8s on Proxmox, and that’s what I’ve been (very slowly) building up to at home.

With Proxmox you can failover VMs between nodes as long as storage (including VM boot disk) is external to the nodes. This can be NFS on a NAS, iSCSI, Ceph or many other options.

It’s even possible to failover a USB device (e.g. a Zigbee controller or similar) by attaching one on each node and mapping them using Resource Mappings (search on the announcement post: https://www.proxmox.com/en/about/press-releases/proxmox-virtual-environment-8-0).

This can also be used if you’re deploying k8s on top of Proxmox just as well.

[–] Cyber 1 points 10 months ago

Ah, ok, thanks... I'll have to dig in to this some more