Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.
this post was submitted on 18 Dec 2023
71 points (98.6% liked)
3DPrinting
15644 readers
171 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Or if you don't screw it in JUST RIGHT It decides to become thinner than water and shoot out the sides 🥹
I've never seen that (I tend to over tighten rather than under), but I can see how that can happen quite often.
Its something really dumb like forgetting to heat up your hotend before you install it and it doesn't make a seal or something