this post was submitted on 30 Nov 2023
0 points (50.0% liked)

Home Networking

189 readers
2 users here now

A community to help people learn, install, set up or troubleshoot their home network equipment and solutions.

Rules

founded 10 months ago
MODERATORS
 

I am sorry in advance if this is the wrong spot to ask for advice....but here goes..

My network consists of 1 fios modem and 2 routers. Basically, the Modem brings the signal, router 1 is a netgear that I want to handle the wireless throughout the house. I would prefer the Modem not handle any of the wifi responsibilities.

Router 2 is in a separate room and is situated there in order to have everything in that room hardwired.

The network, overall is a mess of a mess. It's not streamlined and I am assuming there is non-stop collisions.

Overall, in my head, the set up is Modem-->Router 1 which handles the wireless and a guest network-->router 2 which is really just hardwired back to router 1 so that I can have wired devices for work in a separate room.

I would _prefer_ not to run any more wire even if it means eliminating the second router, but how do I organize all of this so that the network runs at full capacity smoothy and (hopefully) all the devices can see each other for sharing purposes...that part isn't 100% necessary.

you are viewing a single comment's thread
view the rest of the comments
[–] Brkdncr@sh.itjust.works 1 points 9 months ago

There aren’t any collisions.

Disable the router components on router2. If it has an AP or bridge mode do that. If it doesn’t, just turn off dhcp. The “wan” interface should be unplugged. Also change its management ip to something other than router 1’s.

It’s now effectively a layer 2 switch with an access point.