11
Is this one-piece battery-to-PCB "clip" standard (for easy replacement) or a custom piece? +PCB pad ?
(discuss.tchncs.de)
Hello,
No formal training, but do like to repair devices at home (and keep vintage electronics and computers going).
Yet another alkaline battery has leaked prodigiously into a device (after only a few months). A wall-mounted thermostat.
Is the sort of clip pictured, which contacts an AA battery negative terminal at one end, and seemed to just clamp onto a conductive trace at the edge of PCB at the other, an easy-to-find standard form (for replacement) or a custom piece?
It is quite corroded and even peeling, and suspect replacing the clip would be better than devising a work-around.
Visually searching through product photos on supplier websites (like Digi--- and Mous-- here in the US) has not been effective.
Thanks for any comment.
I can't tell if you have gold plate or just raw copper (probably gold. But in either case, yes, it is solderable. You can think a little bit about how they manufacture the boards. First the print on the green solder resist, then they dunk it into an electroplating bath for a gold finish, or a dunk it in solder for HASL. It would be a lot of trouble to go through (=$$$) to individually mask off that part of the board for some special process.