this post was submitted on 13 Sep 2023
43 points (97.8% liked)
Linux
48102 readers
691 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The home NAS case market is so frustrating. For my next build, I'm going to design a 3D printed interface to use an 8-bay supermicro backplane like the BPN-SAS-747TQ, build a simple aluminum box around it with 2x120mm fans in the rear, and just run SATA and power to a PC case sitting next to it. It would even be straightforward to have activity lights and everything. Good drive temps, low noise, cheap and replaceable backplane, cheap enclosure, and full freedom of PC case choice to optimize for size or cooling or whatever. Sure, it'll be a bit bulky and a bit ugly, but I'd much rather take those downsides over noise, cost, or heat.
I can totally understand your frustration! I wish there was a product available that could do everything I want, but there isn't, and I have access to a 3D printer through my local makerspace. I will say that there are a bunch of ways to get prints made and shipped to you if you don't have access to one. I also think that lots of people 3D print things when they don't need to. When I make the enclosure that I mentioned, only the bare minimum will be 3D printed, and the rest of the enclosure will use off-the-shelf parts, a readily available backplane, and will be able to be built with simple tools.